HELP & FREQUENTLY ASKED QUESTIONS

SPRING REVERB II

  • If you are in mono mode and find that your output is muted in bypass, check the the mini switch on the PCB is set to ‘M’ for mono. Check the manual to find the location of the switch.

  • In ECHOVERB mode, the subtle delay/echo can become less present with increased amounts of modulation (Layer 1 MOD). Reduce the MOD amount to gain more clarity on the echo.

    Also check the position of the L2 Micro Tune Delay Time knob. Try increasing for a longer Delay time.

  • Yes, the knob positions for the current layer are maintained / saved as you switch from one layer to the other.

LO-FI DELAY

  • Check you have not set the Wet/Dry toggle switch to Dry. In Dry mode the input to the delay channel is only active when SPLASH footswitch is momentarily held down.

ROUNDHOUSE

  • Currently the multiplier is preset depending on what the current master Speed is set to. Slower speeds will go up to x6 over about 3 seconds, faster speeds will only double over about 1-2 seconds.

FAQ

  • Colortone recommend an Isolated Power Supply providing 9VDC (Centre Pin Negative) with at least 150mA current

  • Yes, our Pedals are True Bypass and incorporate a hardware based Relay switching mechanism. Should power be lost to your pedal board the Relay will default to Bypass mode and pass through the incoming audio.

  • The faceplates are made from Stainless Steel. Clean with a basic degreaser like soap and water. Buffing clean with a micro fiber cloth will bring back the lustre of the original finish and remove finger and dirt marks

  • The ‘Headliners’ knob caps are made from a flexible silicone. Simply line up the Line with the Dot on the knob, place one end under the lower ridge of the knob and pull and stretch over the entire face. Then run your finger around the lower lip to make sure it is sitting flush all the way around.

  • We are happy to take on One-Off feature requests. Contact us via the Contact Page and outline what features / enhancements you would like.

  • Colortone pedals are available worldwide from the stores listed in the Retailers Page. They can also be purchased through this online store, shipping from the USA.

  • Firmware updates and “how to” instructions are available on this page.

  • The best way is to go to the Firmware Update Page and read the Release notes for each version. The notes outline feature updates and bug fixes. If it feels like your Pedal does not have one of these features/fixes then proceed to updating the firmware if you want to.